PCT 200 High Reliability Thru-Hole Soldering Technology Rework and Repair Course is a four-day certification course with instruction and hands-on training on stranded wire preparation and soldering to a variety of terminal types, PCB soldering and de-soldering on single-sided and double-sided circuits as well as PCB and conductor repair of single-sided, double-sided and flexible circuit boards including identification and removal of conformal coatings.
PCT 300 Multi-layer and Flexible Circuit Repair Course is a four-day certification course with instruction and hands-on training on excavation to and repairs of internal conductor damage on multi-layer PCB's, laminate removal and repair of damaged conductors on flexible circuits and the repair of end of run through-holes on both of these assembly types.
PCT 400 Surface Mount Technology Rework and Repair Course is a four-day certification course with instruction and hands-on training on the installation and removal of all standard surface mount components using both conductive and convective techniques as well as repairs of damaged lands and traces.
PCT 500 Advanced Surface Mount Technology Rework Course is a four-day certification course with instruction and hands-on training focusing on the most difficult fine pitch surface mount components and profiling, alignment, installation, inspection, removal and refurbishing of area array components (BGA's).
Custom Classes – CTI will customize classes for virtually any electronic application.
All IPC classes are taught to current revision, however down-level revision classes can be taught if necessary.
All of our solder training classes can be taught onsite at your facility if needed. We can customize most of the classes to accommodate special requirements that you may have. Obviously for the IPC certified classes we must follow IPC guidelines, but at the same time with our vast experience with IPC and knowledge of the real world of soldering we are usually able to adapt these classes to meet your specific needs. |
